Page 1 of 1

variable zoom in/out

Posted: Wed May 30, 2007 6:13 pm
by rmandel
It would be nice to specify, per map, a zoom percentage. I use aeronautical sectional charts and it zooms only at a factor of 11. Somewhere in between would be perfect. I suppose I could resize the .jpg before I calibrate.... but those files are huge. Plus I might have different uses for one map, where the zoom factor is important.

-RM

Posted: Fri Jun 01, 2007 12:16 am
by Scott
I suggest you generate other map "layers" at 25% and 50% resolution.

This way you can quickly zoom (using Up-Down zoom buttons) to desired resolutions. Map quality and program performance is also better than zooming by scaling the map on- the-fly.

Posted: Sun Jun 06, 2010 12:48 am
by patricksnead24
Hi,

I had the same question. I will try to generate the map "layers" at 25% and 50% resolution..........


Thanks,