Page 1 of 1

Long/Lat when calibrating map

Posted: Fri Jun 15, 2007 6:28 pm
by rmandel
It would be nice, once a map is calibrated to have crosshairs and a long/lat display. It would make it easier to know if you have properly calibrated the map by being able to mouse to a known location.

Posted: Fri Jun 15, 2007 6:51 pm
by Plenz
I support this. Some weeks ago I captured a map from the internet, calibrated it and tried it out, but something was wrong. It took some time until I found out that the map was turned by 4 degrees. So I think it is very important to check some known points to make sure that the map is correctly calibrated.

Posted: Sun Jul 01, 2007 4:22 pm
by jp
Would be really good. Any feature which helps calibrate maps are important since this process is really time consuming and difficult to get right.